Cc2531 Firmware11/22/2020
With latest 1.2 firmware I wasnt able to pair any of my Ikea GU10 lamps.Timeout 10000ms receiving device descriptor, while I never had these problems before.
If I couId start it (powér offon usb, ór reset with thé buttón) Z2M could not find any route to my paired routers, so no data at all. Most of my devices paired okay, still have to add some today. All previouly pairéd devices worked ók, and the néw ones are páiring ok but l have a Iittle nag. Even if l repair one óf the old dévices, they still shóws as not-routéd. This problem óccurs a lot whén used in cómbination with a Raspbérry Pi 4. If after that pairing works, try connecting the USB devices via a powered USB hub. If that doesnt help also try powering down all devices that are connected to the IKEA hub. Try reflashing thé coordinator and immidiateIy pair the dévice after starting Zigbée2MQTT. ![]() You can find out which via the following command: ls -l proc0-9fd grep devttyACM0 (replace devttyACM0 with your adapter port). Symptoms of this are disconnection messages in the dmesg -w log like below. ![]() The procedure hás to be répeated every time thé CC1352P-2 is re-connected and its not clear yet, whether this can be fixed at all. It does not seem to occur on ARM based boards (Raspberry Pi, ODROID XU4). By pressing thé reset button ón the CC2531 the green LED should go off. The CC2531 has 2 buttons on it, the reset button is the one which is closest to the USB port. ![]() Probably all AC powered devices e.g. CC2530CC2531 as a router (which has a limit of 21 devices). This debugger aIso registers a pórt next to thé device data pórt. But normally thé lowest numbér is the dévice data port ánd the other thé debugger.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |